The DSE8005 will monitor up to a maximum of 40 DSE controllers in any combination of up to 32
generators and 10 mains (utilities) e.g. 32 generators and 8 mains (utilities), 30 generators and 10
mains (utilities) etc.

For more information please refer to the DSE8600 Series or DSE8700 Series manuals.

The DSE865 is an RS485 communications devices that allows you to monitor single generating sets over a LAN (network) or WAN (internet) connection. The device includes software that is used to assign a TCP/IP address to a COM Port on a PC. This COM port is then selected by the user in the standard
PC software of the DSE module being used. Once this COM port has been selected then the user can
communicate directly with the control module from their PC.

If the device needs to be seen over the internet the assigned IP address has to be configured to be
visible to the outside world. Once this has been done the module can be communicated with from any
remote location that has internet connectivity.

The device has been designed to work with the DSE73xx and DSE75xx control modules.

The devices also include LED indicators that show the operation and connection status at all times.
Different light patterns indicate a range of status conditions.

The DSE860 is an RS232 communications device that allow you tomonitor single generating
sets over a LAN (network) or WAN (internet) connection. The devices include software that is used to
assign a TCP/IP address to a COM Port on a PC. This COM port is then selected by the user in the standard PC software of the DSE module being used.

Once this COM port has been selected then the user can communicate directly with the control module from their PC.  If the device needs to be seen over the internet the assigned IP address has to be configured to be visible to the outside world. Once this has been done the module can be communicated with from any remote location that has internet connectivity

Multi Set Communication Software

Deep Sea Electronics DSE850 Multi-Set Communications Software has been designed to work with the
DSEPower Series Load Share Control Modules (DSE55xx and DSE75xx). The software is scheduled to be compatible with additional DSE controllers in the near future.

The DSE Ethernet controller is connected to the internet and all DSE control modules that are on-site. The Ethernet controller requires a fixed internal IP address that can be configured to be visible over the internet (using third party external router). Once the IP address can be accessed over the internet
then sites can be viewed from any internet connection in the world.

The system has been designed to display information on a maximum of 16 gen-sets and 4 mains utilities) or 24 gen-sets with no mains (utilities).The software is easy to set up and DSE controllers can easily be added to the system using the software’s intuitive ‘Add Controller’ page.

The Ethernet device includes RS232 and RS485 communications ports. The data taken from the DSE
controllers is refreshed every 1-11 seconds (dependent on connection speed).